Step Transient Commands - Pacific Power Source LMX Series Operation Manual

8.7.11 STEP Transient Commands

The command in this section control STEP transients. Some of these commands have the
option to specify NORmal or SATurate.
SATurate mode:
NORmal mode:
Command Syntax
Description
Parameters
Parameter Format
Example
Query Format
Returned Data Format
Query Example
Query Syntax
Description
Returned Data Format
Query Example
Command Syntax
Description
Parameters
Parameter Format
Example
Query Format
Returned Data Format
Query Example

Entire Contents Copyright 2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
LMX Series Power Source Operation Manual
If a dwell time setting is out of limits, the dwell time will saturate to the
limit min/max and it will not trip an error.
If a dwell time setting is out of limits, an error will be generated and
the dwell time setting will not be modified.
[SOURce:]STEP:MODE < INIDEL | 0 | FINDEL | 1 | INIFIN | 2 >
This command sets the programming mode for a STEP Transient.
0 | INIDEL Allows programming the step by initial and delta values
1 | FINDEL Allows programming the step by final and delta values
2 | INIFIN Allows programming the step by initial and final values
< INIDEL | 0 | FINDEL | 1 | INIFIN | 2>
<cr> or <nr1>
STEP:MODE 1
[SOURce:]STEP:MODE?
<nr1>
STEP:MODE?
1
[SOURce:]STEP:MODE:CATalog?
This command returns the available mode settings for a STEP
Transient.
0 | INIDEL Allows programming the step by initial and delta values
1 | FINDEL Allows programming the step by final and delta values
2 | INIFIN Allows programming the step by initial and final values
<nr1>
STEP:MODE:CAT?
0,Initial and delta,1,Final and delta,2,Initial and final
[SOURce:]STEP:INITialvalue <OFF|0|ON|1>
This command determines if an initial value step is inserted at the
beginning of each repeat of a step transient.
0 | ON Allows programming the step by initial and delta values
1 | OFF Allows programming the step by final and delta values
< OFF | 0 | ON | 1 >
<cr> or <nr1>
STEP:INIT ON
[SOURce:]STEP:INITialvalue?
<b>
STEP:INIT?
1
LMX SERIES™ OPERATION MANUAL
Remote Control Programming
SECTION 8:
Page 281 of 463