Pacific Power Source LMX Series Operation Manual page 447

Error Source Code
Front panel 337
Front panel 338
Front panel 341
Front panel 342
Front panel 343
Front panel 344
Front panel 345
Front panel 346
Front panel 347
Front panel 348
Front panel 349
Front panel 350
Front panel 351
Front panel 352
Front panel 353
Front panel 354
Front panel 355
Front panel 356
Front panel 357

Entire Contents Copyright 2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
LMX Series Power Source Operation Manual
Category Error Message
Internal Missed node.
Error
Error One or more enhanced
controllers did not get
enabled.
Internal Firmware version
Error mismatch. Power stage
version is older than
expected.
Internal Firmware version
Error mismatch. Front panel
version is older than
expected.
Error Mismatch between
hardware revisions of
units in parallel.
Error Power stage firmware
update failed.
Error Firmware update was
interrupted.
Error GPIB hardware not found
in this unit.
Error GPIB hardware detected
Error IO hardware not found in
this unit.
Error IO hardware detected
Internal Analog inputs cannot be
Error read.
Error Transformer hardware
detected.
Error Ambient temperature
exceeded maximum limit.
Error Enhanced controller
hardware not found in
this unit.
Error Enhanced controller
hardware detected.
Error Mismatch between
models of units in
parallel.
Error Unit model mismatch.
Internal Digital inputs cannot be
Error read.
LMX SERIES™ OPERATION MANUAL
SECTION 12: Warnings & Error Messages
Possible Cause
completing front panel
firmware update
An inconsistency was
detected in the power
source's internal
communication network.
Failed to enable one or
more controllers
Firmware Error. Power
stage firmware version is
older than expected
Firmware Error. Front
panel firmware version is
older than expected
Error during discovery.
Not all paralleled units
are of same hardware
revision
Run
SYSTem:FW:INT:UPDATE:
STAT? for more
information.
Recovery is needed.
Configuration Error. GPIB
Interface option not
found
Configuration Error. GPIB
Interface found but not
configured
Configuration Error. Aux
I/O hardware missing
Configuration Error. Aux
I/O hardware found but
not configured
Configuration Error. No
data received from
analog inputs
Unit model mismatch.
Unit model mismatch.
Resolution
Try recycling power. If
error persists, contact
customer service
Try recycling power. If
error persists, contact
customer service
Contact customer service
Contact customer service
Contact customer service
Run unit discovery to
recover
Run unit discovery to
recover
Check model type tag for
installed options
Check model type tag for
installed options
Check model type tag for
installed options
Check model type tag for
installed options
Check connections to
AUX I/O connector and
pin assignments
Page 447 of 463