Access Control - Pacific Power Source LMX Series Operation Manual

10.10.5 Access Control

The access control screen allows restricting access to the power source over the LAN interface.
This is an important requirement for power sources connected to a company wide Ethernet
network. Without access restrictions, persons not present where the power source is located
could inadvertently cause a dangerous condition by either enabling the OUTPUT or changing
programmed settings.
Access control can limit access from specific IP addresses only and requires someone physically
present where the power source is to grant access to anyone else.
For more details, refer to section 10.3, "Access Control" on page 374 of this manual.

Entire Contents Copyright 2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
LMX Series Power Source Operation Manual
LMX SERIES™ OPERATION MANUAL
LAN Interface Configuration
SECTION 10:
Page 417 of 463