Table of Contents
Advertisement
10.9.1 Unit Settings
Unit settings determine the mode of operation of the power source. This includes phase mode,
voltage range, output mode, update phase angle and ramp time for any output value changes
made.
•
Output enable at power on allows the unit to power up with the output enabled.
The Enable Current Overload setting allows short duration overloads up to 30% over the
•
normal continuous mode current limit set point.
•
Phase Rotation selection changes output phasing between positive (leading) and
negative (lagging) phase rotation in three phase output mode.
•
The maximum adjustment limit for continuous self-calibration mode and fault
generation on saturation can be set from this screen as well.
The right hand side of the screen contains Transient mode execution settings.
•
•
Language selections are either ENGLIGH or CHINESE.
These can all be set from the CONFIGURATION -> UNIT SETTINGS screen shown below.
Entire Contents Copyright
2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
LMX Series Power Source Operation Manual
LMX SERIES™ OPERATION MANUAL
LAN Interface Configuration
SECTION 10:
Page 409 of 463
Advertisement
Table of Contents
