Source Commands; Source Configuration Programming Commands - Pacific Power Source LMX Series Operation Manual

8.7 Source Commands

Source commands control the settings of the power source. This includes all operating
modes, voltages, frequency, current and power limits and phase angles as well as transient
operation. Since the SOURCE subsystem is the primary system, the SOURce portion of these
commands is optional. The following status commands are supported broken down by
SOURCE sub groups.
8.7.1

Source Configuration Programming Commands

Command Syntax
Description
Parameters
Parameter Format
Example
Query Format
Returned Data Format
Query Example
Command Syntax
Description
Parameters
Parameter Format
Example
Query Format
Returned Data Format
Query Example

Entire Contents Copyright 2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
LMX Series Power Source Operation Manual
[SOURce:]CONFIG <b>
Selects alternative loop compensation mode for improved transient
response. The effect of this command depends on the selected
output mode as follows:
AC Mode: Changes the AC loop compensation.
< 0 | 1 > ( 0 = Normal loop, 1 = Faster Loop )
<b>
SOUR:CONFIG 1
[SOURce:]CONFIG?
<b>
CONFIG?
0
[SOURce:]CONFIG:AC <b>
Selects alternative AC loop compensation mode for improved AC
transient response.
The effect of this command depends on the selected output mode as
follows:
AC Mode: Changes the AC loop compensation
< 0 | 1 > ( 0 = Normal loop, 1 = Faster Loop )
<b>
SOUR:CONFIG:AC 1
[SOURce:]CONFIG:AC?
<b>
CONFIG:AC?
0
LMX SERIES™ OPERATION MANUAL
Remote Control Programming
SECTION 8:
Page 245 of 463