Phase Sync Output - Pacific Power Source LMX Series Operation Manual

7.6.2

Phase Sync Output

The phase sync output signal can be programmed to generate an output pulse at each zero
crossing of the phase A voltage. This indicates the 0° phase angle output on Phase A.
The mode can be set from the front panel or by using the following SCPI commands:
The following specifications apply to the external trigger output:
Output Voltage @ 0.4 mA Logic Low Vout < 0.4 V
Max. Current
Output Impedance
Pulse Width

Entire Contents Copyright 2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
LMX Series Power Source Operation Manual
SECTION 7: Auxiliary I/OError! Reference source not found.
SYNC
IN/OUT
Log High Vout > 4.6 V
± 10 mA
100 Ω
100 us ± 10 us
Figure 7-8: Phase A Zero Phase Sync Output Pulse
LMX SERIES™ OPERATION MANUAL
Page 187 of 463