Table of Contents
Advertisement
10 LAN Interface Configuration
10.1 Overview
All LMX models are equipped with a LAN (Ethernet) interface. As shipped, the unit automatically
obtains an IP address from the network using the DCHP protocol. If the instrument is turned off
for long periods, the IP address lease may expire and a new IP address will be assigned. If this is
the case, it is possible to assign a fixed IP address instead.
10.2 Web Browser Interface
The LMX Series® conforms to the LXI (Lan eXtensions for Instrumentation) standard and as such
as a built in web server. This allows communication with the LMX from any web browser as long
as the LMX is on the same network.
Note: The LMX web server has been tested with Google Chrome and Mozilla Firefox browsers
only. Microsoft Internet Explorer is now obsolete and is not supported. Other browser
like Edge or Safari may not fully operate or display information correctly.
Note: Web server use from a browser is not supported in UPC Compatibility mode. Disable this
mode when operating the LMX from a web browser.
Use the IP address shown in the LAN INTERFACE SETUP screen under the SYSTEM key to
determine the IP address to type into the web browser.
CAUTION: BEFORE USING BROWSER CONTROL
Verify that the level of remote access control is appropriate for the situation at hand. The power
source is capable of producing lethal output voltage and operating it without being physically in the
same room or space present a safety risks to others. Refer to 10.3.2, "Front Panel Access Control".
Entire Contents Copyright
2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
LMX Series Power Source Operation Manual
LMX SERIES™ OPERATION MANUAL
LAN Interface Configuration
SECTION 10:
Page 372 of 463
Advertisement
Table of Contents
