Table of Contents
Advertisement
Query Format
Description
Parameters
Returned Data Format
Query Example
Query Format
Description
Parameters
Returned Data Format
Query Example
Command Syntax
Description
Parameters
Parameter Format
Example
Entire Contents Copyright
2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
LMX Series Power Source Operation Manual
PROGram[:SELected]:CHECK? [,<nr1>] [,<cr>]
This command performs a check on the selected program steady
state tables looking for the following conditions:
Hardware Limit violations
•
User Limit violations
•
Saturation limits.
•
If no violations are present, this command returns OK and the
program can be executed without generating any errors. If the
selected program cannot be run due to one or more issues with its
content, one or more errors detailing the issues will be returned.
For example, if the upper voltage user limit is set to 100V and the
program contains a setting of 300V, a "Cannot load program, Run
PROGRAM:CHECK?" error will be generated when attempting to
execute this program. When sending the PROGRAM:CHECK? Query,
the response will be "VOLT1 AC voltage set point cannot change due
to user limit".
Option: PROGRAM NUMBER [,<nr1>]
Option: MEMORY [,<cr>]– Available are: INTERNAL | RAM | USB
<cr>
PROG:CHECK?
VOLT1 AC voltage set point cannot change due to user limit
PROGram:EXECuted:CHECK? [,<nr1>] [,<cr>]
This command serves the same purpose as the PROG:CHECK?
Command but applies to a program that is executing.
Option: PROGRAM NUMBER [,<nr1>]
Option: MEMORY [,<cr>]– Available are: INTERNAL | RAM | USB
<cr>
PROG:EXEC:CHECK?
VOLT1 AC voltage set point cannot change due to user limit
PROGram[:SELected]:DELete
This command deletes the selected program. Attempting to DELete
an EXECuting Program will result in an Error.
Program number
<nr1>
PROG:DEL 9
LMX SERIES™ OPERATION MANUAL
Remote Control Programming
SECTION 8:
Page 234 of 463
Advertisement
Table of Contents
