Pacific Power Source LMX Series Operation Manual page 394

10.7.6.1 Data Points
Waveform creation using direct data entry for each data point is faster when using fewer data
points. Examples below show sine wave creation using either 16 or 4 data points. However,
data is interpolated linearly for points no displayed in the table on the right hand side.
Figure 10-5: Waveform Edit defined using 4 data points
Figure 10-6: Waveform Edit defined using 16 data points

Entire Contents Copyright 2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
LMX Series Power Source Operation Manual
LMX SERIES™ OPERATION MANUAL
LAN Interface Configuration
SECTION 10:
Page 394 of 463