Table of Contents
Advertisement
5.5 Verify Correct AC Input Line Voltage
The LMX Series® power supply is available with either single or three phase AC input voltage
configurations and supports multiple input voltage settings. Prior to connecting the AC
power source to the local mains, it is important to check the type label on the unit to verify
that its AC input configuration matches the local utility power.
Do not connect the power supply to the mains if the AC input voltage, phasing and
frequency does not match.
DO NOT
CONNECT AN LMX MODEL TO AN INCORRECT
UTILITY LINE VOLTAGE AS DAMAGE TO THE UNIT MAY
NE PAS
CONNECTER UNE LMX MODÈLE À UN UTILITAIRE
TENSION EN PANNE QUI PEUT SE PRODUIRE.
5.6 AC Input Connections
For models 105,108,112,305,308,312 and 320LMX, an input power cord and plug is provided
to meet ETL safety standard requirement.
For models 140, 345 and 360LMX, an input terminal block cover is provided to meet ETL
safety standard requirement. Use of the cover is mandatory and "Knock-outs" are provided
for wiring to the rear panel input terminal block.
Input voltage form and requirements of the input wiring for the LMX-Series Power Source
varies by model. Each is discussed in a separate sections following. Please refer to the
appropriate models section paragraph for the model being configured.
Entire Contents Copyright
2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
LMX Series Power Source Operation Manual
WARNING
OCCUR.
AVERTISSEMENT
LMX SERIES® OPERATION MANUAL
Unpacking and Installation
SECTION 5:
Page 54 of 463
Advertisement
Table of Contents
