Table of Contents
Advertisement
2
Speed: Allows accelerating the speed of the internal synchronization engine (PLL) in
case the external sync source is not constant and presents periodic or continuous
changes. A slower speed improves the stability of the waveform frequency, so it is
recommended to use the smallest possible speed values.
Command: SOURce:SYNChronize:SPeed
3
Range: Allows configuration of how much the synchronization engine is able to
deviate from the LMX programmed frequency. This helps to keep the waveform
frequency under control, even if the external source is not present all the time. The
synchronization engine is limited to frequencies of FSETPOINT +/- FRANGE.
Command: SOURce:SYNChronize:RANGe
7.6 Digital Output control signals
•
External Relay Control #1 - FORM
•
External Relay Control #2 - TRANSFORMER
•
Trigger Output / Function Strobe
•
Phase Sync Output
7.6.1
Function Strobe / Trigger Out
The external trigger output can be programmed to generate an output pulse on the
following events:
a. The start of a transient program (Transient Trigger)
b. Output Replay State Change
c. Any parameter change. Parameter changes that generate an output function strobe
pulse are:
i. Voltage on any phase
ii. Frequency
iii. Waveform on any phase
iv. Phase angle
Entire Contents Copyright
2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
LMX Series Power Source Operation Manual
LMX SERIES™ OPERATION MANUAL
SECTION 7: Auxiliary I/OError! Reference source not found.
TRIGGER
OUT
Page 185 of 463
Advertisement
Table of Contents
