Table of Contents
Advertisement
10.7.6.2
Waveform Tools
The following Waveform Tools are available:
CONTROL
TOOLS
PRESETS
PARAMETERS
Entire Contents Copyright
2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
LMX Series Power Source Operation Manual
Purpose
These selections created specific waveform types without having to define data values
manually. Following functions are available from this drop-down:
NORMALIZE
Normalizes waveform for zero DC offset.
RECTIFY
Rectifies the waveform. Only positive data points remain. This implies a
DC offset which is shown in the DC display field below the graph.
FREQ MULTIPLY
Creates specified number of periods to multiply fundamental frequency.
Use caution with resulting higher frequency waveforms as power source
has a finite bandwidth and output may fault if too much high frequency
content is present.
OFFSET
Applies specified DC offset.
SCALE
Multiplies all data points by scale factor value.
VERTICAL FLIP
Flips waveform vertically.
HORIZONTAL FLIP
Flips waveform horizontally.
SMOOTHING FILTER Smooths sharp edges to reduce bandwidth requirements.
PRESET
Selects built-in waveform types based on user parameters.
The following PRESET waveforms are available:
NONE
Default or no selection made.
SINE, TRIANGLE, SQUARE, 6 STEPS, 12 STEPS, SINE POWER, CLIPPED SINE, SAWTOOTH,
PULSE, IMPORTED WAVEFORM
The following parameters are settable for each PRESET selection:
HARMONIC
H1 through H32
SCALE
Vertical Scale Multiplier
PHASE
Start phase angle
OFFSET
DC Offset
EXPONENT
1 through 51. Applies to SINE POWER present only.
THD
0% through 100%. Applies to CLIPPED SINE only.
RISE TIME
0° through 360°. Applies to PULSE preset only.
PULSE WIDTH
0° through 360°. Applies to PULSE preset only.
FALL TIME
0° through 360°. Applies to PULSE preset only.
LOAD FROM FILE
Available for IMPORTED WAVEFORM preset only.
ADD
Add to existing waveform (summation)
REPLACE
Replace existing waveform with selected PRESET
LMX SERIES™ OPERATION MANUAL
LAN Interface Configuration
SECTION 10:
Page 395 of 463
Advertisement
Table of Contents
