Other Measurement Commands - Pacific Power Source LMX Series Operation Manual

Command Syntax
Description
Parameters
Parameter Format
Example
Query Format
Description
Returned Data Format
Query Example
Command Syntax
Description
Parameters
Parameter Format
Example
Query Format
Description
Returned Data Format
Query Example
8.4.6

Other Measurement Commands

Query Format
Description
Returned Data Format
Query Example

Entire Contents Copyright 2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
LMX Series Power Source Operation Manual
MEASure:KWHour:RESET
This command resets all energy measurements to zero and resets the
time counter.
None
n/a
MEAS:KWH:RESET
MEASure:KWHour:ETIMe?
This command returns the accumulated energy measurement time in
seconds.
<nr2>
MEAS:KWH:ETIM?
120.5
MEASure:KWHour[:STATe] <b>
This command enables or disables the KHh measerments. When
enabled, the energy time counter starts till reset with the
MEASure:KWHour:RESET command.
< 1 | ON | 0 | OFF >
<b>
MEAS:KWH ON
MEASure:KWHour[:STATe]?
The query format of this command returns the setting of the KWh
measurement as either 1 (ON) or 0 (OFF).
<nr1>
MEAS:KWH?
1
MEASure:TEMPerature:AMBient?
Returns the ambient temperature of the power source in degrees
celcius.
<nr1>
MEAS:TEMP:AMB?
24
LMX SERIES™ OPERATION MANUAL
Remote Control Programming
SECTION 8:
Page 212 of 463