Table of Contents
Advertisement
6.8 SYST – SYSTEM Screens
The System screens allow setting of secondary system level functions that are used less
often than the first four screens. This generally involves setting system level operation
modes and parameters to tailor the instruments operation to the user's specific
requirements and operating environment. These include the following areas:
•
Remote Control Interfaces
System level settings, logs and firmware updates
•
•
Calibration
•
Parallel Operation
Options if any
•
Pressing the SYST key will display the first of two CONFIGURATION screens as shown below.
The More soft key will allow moving back and forth between the two main SYSTEM screens.
Selections on each screen are made by scrolling through the available entries using the
shuttle knob. Pressing the Enter soft key, ENTER key or shuttle will display the selected
highlighted entry screen.
Entire Contents Copyright
2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
LMX Series Power Source Operation Manual
Figure 6-21: SYSTEM MAIN MENU 1
Figure 6-22: SYSTEM MAIN MENU 2
LMX SERIES™ OPERATION MANUAL
Front Panel Operation
SECTION 6:
Page 157 of 463
Advertisement
Table of Contents
