Program - Pacific Power Source LMX Series Operation Manual

10.7.1 Program

The program control screen allows programming of all output parameters, operating modes etc.
It also displays measurement data for all available phases in the lower part of the screen. In
three or two phase mode, Line-to-Line voltage measurements are displayed at the bottom of
the screen. The Output can be enabled using the "OUTPUT ENABLE" controls in the upper
PROGRAM screen. The Output can also be turned OFF from any screen using the RED On/Off
symbol in the menu bar, which is accessible from all screens. This allows quick opening of the
output relay if needed from any screen without have to first select the PROGRAM screen. Note
that the output can only be turned ON (or OFF) from the PROGRAM screen however.

Entire Contents Copyright 2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
LMX Series Power Source Operation Manual
LMX SERIES™ OPERATION MANUAL
LAN Interface Configuration
SECTION 10:
Page 383 of 463