Execution Commands - Pacific Power Source LMX Series Operation Manual

8.6.2

Execution Commands

The following commands may be used to control stored program executions.
Command Syntax
Description
Parameters
Parameter Format
Example
Query Format
Description
Parameter Format
Example
Command Syntax
Description
Parameters
Parameter Format
Example
Command Syntax
Description
Parameters
Parameter Format
Example

Entire Contents Copyright 2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
LMX Series Power Source Operation Manual
PROGram[:SELected]:EXECute [<nr1> [,<cr>]
This command executes the selected program (default) or the
program number passed as the first parameter.
Option: PROGRAM NUMBER [,<nr1>]
Option: MEMORY [,<cr>]– Available are: INTERNAL | RAM | USB
[<nr1> [,<cr>]
PROG:EXEC 2
PROGram[:SELected]:EXECute ?
The query format returns the number of the program that is in effect.
<nr1>
PROG:EXEC?
23
PROGram:EXECute:TRANS [<nr1> [,<cr>]
This command executes the selected program's (default) transient
table or the program number passed as the first parameter.
Option: PROGRAM NUMBER [,<nr1>]
Option: MEMORY [,<cr>]– Available are: INTERNAL | RAM | USB
[<nr1> [,<cr>]
PROG:EXEC:TRANS 2
PROGram:EXECute:TRANS:RESET
This command serves the same purpose as the "PROGram:TRANsient
STOP" command. See next.
This command resets the active transient execution. This command is
included to support UPC compatibility mode although it is not
documented in the UPC manual. Not recommended for new
programs.
None
n/a
PROG:EXEC:TRANS:RESET
LMX SERIES™ OPERATION MANUAL
Remote Control Programming
SECTION 8:
Page 236 of 463