Transient Segments Commands - Pacific Power Source LMX Series Operation Manual

8.6.3

Transient Segments Commands

The following commands may be used to control stored transient program executions.
Command Syntax
Description
Parameters
Parameter Format
Example
Query Format
Description
Returned Data Format
Query Example
Command Syntax
Description
Parameters
Parameter Format
Example
Query Format
Returned Data Format
Query Example
Command Syntax
Description
Parameters
Parameter Format
Example
Query Format
Returned Data Format
Query Example

Entire Contents Copyright 2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
LMX Series Power Source Operation Manual
PROGram:TRANsient
This command controls transient execution
RUN | STOP | PAUSe | STEP | RESTart
<cr>
PROG:TRAN RUN
PROGram:TRANsient?
Query format returns the transient execution state as either RUN,
STOP, PAUS, STEP or REST
<cr>
PROG:TRAN?
RUN
PROGram:TRANsient:AUTORMS <BOOLEAN>
If enabled, the value of any waveform used in a transient segment is
normalized in order to match the RMS set point.
If disabled, the waveform is reproduced without any normalization.
This function is useful for waveform substitution at the steady state
level.
Note: This function is related to the AUTORMS function in the steady
state segment.
[ 0 | OFF | 1 | ON ]
<b>
PROG:TRAN:AUTORMS 1
PROGram:TRANsient:AUTORMS?
<b>
PROG:TRAN:AUTORMS?
1
PROGram:TRANsient:CR <BOOLEAN>
This command enables or disables the Cycle Reset mode during
transient execution. When on, Cycle Reset will resync each transient
run in repeat mode to the start phase angle.
[ 0 | OFF | 1 | ON ]
<b>
PROG:TRAN:CR 1
PROGram:TRANsient:CR?
<nr1>
PROG:TRAN:CR?
0
LMX SERIES™ OPERATION MANUAL
Remote Control Programming
SECTION 8:
Page 237 of 463