Memory Management Commands - Pacific Power Source LMX Series Operation Manual

8.6.4

Memory Management Commands

The Program memory subsystem commands allow management of Program memory
contents.
Command Syntax
Description
Parameters
Parameter Format
Example
Query Format
Returned Data Format
Query Example
Query Format
Description
Returned Data Format
Memory Types
Query Example

Entire Contents Copyright 2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
LMX Series Power Source Operation Manual
PROGram:MEMory <cr>
This command selects the specific program memory type for storing
and retrieving programs. Default is INTERNAL memory. Alternatives
are RAM and USB devices. The memory type can also be specified as
an optional parameter with several PROGram commands where
indicated in this manual.
Memory types: INTERNAL | RAM | USB.
For a complete list of available memory types, use the
"PROGram:MEMory:CATalog?" Command.
<cr>
PROG:MEM USB
PROGram:MEMory?
<cr>
PROG:MEM?
USB
PROGram:MEMory:CATalog?
This query command returns a comma separated list of available
memory types that can be selected for storage of steady state and
transient table information.
INTERNAL, RAM, SD1, SD2, SD3, USB
INTERNAL = Internal Flash Memory. (Default selection)
RAM = Internal RAM. Content will be lost when power source is
turned off.
USB[X][Y] = USB memory stick devices. X = port number, Y = partition
number
SD[Y] = SC Card, Y = partition number
X = symbolizes different memory sticks connected to various
available USB ports.
Y = symbolizes different logical partitions on a USB memory stick or
SD card.
INTERNAL and RAM are always available. INTERNAL is default
selection. Use the "PROGram:MEMory <cr>" command to select
active memory selection.
PROG:MEM:CAT?
INTERNAL,RAM,USBA1
LMX SERIES™ OPERATION MANUAL
Remote Control Programming
SECTION 8:
Page 242 of 463