Pacific Power Source LMX Series Operation Manual page 311

Command Syntax
Description
Parameters
Parameter Format
Example
Query Format
Description
Returned Data Format
Query Example
Command Syntax
Description
Parameters
Parameter Format
Example
Query Format
Description
Returned Data Format
Query Example
Query Format
Description
Returned Data Format
Query Example
Query Format
Description
Returned Data Format
Query Example

Entire Contents Copyright 2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
LMX Series Power Source Operation Manual
[SOURce:]INTHarmonic:PHASe#
This command sets the interharmonic voltage phase angle with
respect to the phase A interharmonic fundamental for the selected
phase (2 = B, 3 = C) or for both phases if the phase selection is
omitted in degrees.
Phase
<nr2>
INTH:PHAS2 45.00
[SOURce:]INTHarmonic:PHASe?
Query format returns the interharmonic voltage phase angle with
respect to the phase A setting.
<nr2>
INTH:PHAS2?
45.0000
[SOURce:]INTHarmonic:PHASe#:DEFault
The default interharmonic voltage phase angle for each phase or all
phases can be selected using the following command: Factory default
is 0.000° for phase A, 120.000° for phase B and 240.000° for phase C.
Frequency
<nr2>
INTH:PHAS2:DEF 90
[SOURce:]INTHarmonic:PHASe#:DEFault?
Query format returns the interharmonic default voltage phase angle
setting.
<nr2>
INTH:PHAS:DEF?
0.0000, 90.0000, 240.0000
[SOURce:]INTHarmonic:PHASe#:MAXimum?
Returns the upper interharmonic voltage phase angle setting range
for each phase or all phases. The Maximum set values in 360.000°.
<nr2>
INTH:PHAS:MAX?
360.0000
[SOURce:]INTHarmonic:PHASe#:MINimum?
Returns the lower interharmonic voltage phase angle setting range
for each phase or all phases. Minimum set value is 0.000°.
<nr2>
INTH:PHAS:MIN?
0.0000
LMX SERIES™ OPERATION MANUAL
Remote Control Programming
SECTION 8:
Page 311 of 463