Table of Contents
Advertisement
NORMAL EXECUTION MODE
Transient execution is controlled from the TRANSIENT PROGRAM screen. If no transient data
has been entered, no run mode soft key will be visible. In that case, you must use the
"Create" soft key to create a new transient sequence table.
The TRANSIENT PROGRAM screen is shown below.
There are three user settable parameters that control execution of the transient sequence.
They are:
1. Run from step #
2. Run to step #
3. Repeat times
Transients will be executed when the "Run" soft key (SK1) is pressed. If the output if OFF
however, a message will appear indicating the output must be turned ON first.
The transient execution will start at the step # set and run until the Run to step value is
reached. In the example above, from step #1 through step #6 inclusive.
The "Repeat times" field determines how many times the same sequence will be repeated.
To run a sequence indefinitely or until manually stopped, use the shuttle to scroll down to
zero or enter zero in this field using the keypad. This will set the repeat field to
"indefinitely".
The following soft keys are available on the TRANSIENT PROGRAM screen.
SOFT KEY
Run (SK1)
Edit (SK2)
Debug (SK3)
Stop (SK4)
Entire Contents Copyright
2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
LMX Series Power Source Operation Manual
Description
Starts the transient from the "Run from step#" row number
Displays the TRANSIENT VIEW edit mode screen. See section 6.6.3
Displays the TRANSIENT VIEW debug mode screen.
Only appears if "Repeat time" value is set to "indefinitely". Press
to stop execution manually
Table 6-13: Available TRANSIENT PROGRAM screen soft keys
LMX SERIES™ OPERATION MANUAL
Front Panel Operation
SECTION 6:
Page 126 of 463
Advertisement
Table of Contents
