Strobe Output; Remote Control - Pacific Power Source LMX Series Operation Manual

• STATUS
IMMEDIATE
•
• AUTORUN

7.12.9 Strobe Output

The Strobe Output is used to synchronize or trigger external equipment to an event
occurring on the AC power source.
Available settings are:
TRANSIENT
•
OUTPUT STATE
•
• SOURCE

7.12.10 Remote Control

The remote control input is used to control operation of the output relay.
Available settings are:
• DISABLED
REMOTE INHIBIT
•
• REMOTE ENABLE
See Section 6.8.5.6.

Entire Contents Copyright 2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
LMX Series Power Source Operation Manual
SECTION 7: Auxiliary I/OError! Reference source not found.
[ ON | OFF ] Enabled or disabled
[ ON | OFF ] Ignore phase update setting if ON
[ ON | OFF ] No RUN command required if ON
ON = Strobe output on transient start
ON = Strobe output on relay close
ON = Strobe output on any program parameter change
No remote output control
Contact closure needed to close output relay
Contact closure or front panel can control output relay
LMX SERIES™ OPERATION MANUAL
Page 201 of 463