Prog - Program & Measurements Screen - Pacific Power Source LMX Series Operation Manual

6.4 PROG – PROGRAM & MEASUREMENTS Screen
There are two available PROGRAM screen types:
PROGRAM – Displays output settings for all phases and allows individual phase
•
programming. No measurements are visible on this program screen.
• PROGRAM & MEASUREMENT – Combines programming of voltage, current and
power output settings with measurements for all available phase. Frequency
changes cannot be made from this program screen.
Either screen can be used to program the output and toggling between screens is done by
pressing the "Change Style" soft key (SK1).
Output parameters can set from the PROGRAM screen or the PROGRAM & MEASUREMENTS
screen. Each setup parameter can be changed by highlighting the field and either slewing
the value using the shuttle knob or entering a value using the numeric key pad. The
difference between these two data entry modes is that slewing causes the output to change
as the knob is turned while using the keypad allows one or more parameters to be preset to
a new value which won't become active until the "Apply All" soft key or the ENTER key is
pressed.
Thus to slew a value, proceed as follows:
1. Use shuttle to move the active field to the parameter you want to slew.
2. Press the shuttle once to enter the slew mode. The selected field will be
highlighted.

Entire Contents Copyright 2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
LMX Series Power Source Operation Manual
LMX SERIES™ OPERATION MANUAL
Front Panel Operation
SECTION 6:
Page 92 of 463