Remote Control Command Descriptions By Subsystem - Pacific Power Source LMX Series Operation Manual

Character
Carriage Return
Line Feed

8.2 Remote Control Command Descriptions by Subsystem

This section covers detailed description of the available commands by category. The
following command categories are defined.
Command Subsystem
CALIBRATE
MEASURE
OUTPUT
PROGRAM
SENSE
SOURCE
STATUS
SYSTEM

Entire Contents Copyright 2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
LMX Series Power Source Operation Manual
ASCII
<CR>
<LF>
Description
These commands perform calibration functions
These commands are used to measure voltage, current,
power and any other measurement parameters from the
instrument.
These command control the power source output
These commands control programmed settings and
transient segments
These commands control the voltage sense modes
These commands are used to set instrument settings
These commands are used to control or query status and
error messages.
These commands are used to control system level setting
such as interfaces, special operating modes or other special
instrument specific functions.
Table 8-1: Available SCPI Command Subsystems
LMX SERIES™ OPERATION MANUAL
Remote Control Programming
SECTION 8:
Dec value
13
10
Hex value
0x0d
0x0a
Page 204 of 463