Pacific Power Source LMX Series Operation Manual page 257

Command Syntax
Description
Parameters
Parameter Format
Example
Query Format
Returned Data Format
Query Example
Command Syntax
Description
Parameters
Parameter Format
Example
Query Format
Returned Data Format
Query Example
Command Syntax
Description
Parameters
Parameter Format
Example
Query Format
Returned Data Format
Query Example
Query Format
Description
Returned Data Format
Query Example

Entire Contents Copyright 2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
LMX Series Power Source Operation Manual
[SOURce:]CURRent:PROTect:LEVel
This command sets the programmable current trip level for all
phases. The value set cannot exceed the maximum current capability
of the power source as returned by the
"[SOURce:]CURRent:LIMit#:MAX?" command.
If the load current exceeds the current trip set point, the source will
turn off its output after the "CURRent:PROTect:TOUT" delay time
outs and generate a fault message.
0.00 – MAX
<nr2>
CURR:PROT:LEV 24.0000
[SOURce:]CURRent:PROTect:LEVel?
<nr2>
CURR:PROT:LEV?
24.0000
[SOURce:]CURRent:OVerload
This command turns the overload current mode on or off
[ 0 | OFF | 1 | ON ]
<b>
SOUR:CURR:OV ON
[SOURce:]CURRent:OVerload?
<b>
CURR:OV?
1
[SOURce:]IPROTect:STATe
This command turns the current protection mode on or off
[ 0 | OFF | 1 | ON ]
<b>
IPROT:STAT ON
[SOURce:]IPROTect:STATe?
<b>
IPROT:STAT?
1
[SOURce:]IPROTect:TRIPped?
This command returns the current protection state. If the peak
current protection has been tripped, a 1 is returned.
<b>
IPROT:TRIP?
0
LMX SERIES™ OPERATION MANUAL
Remote Control Programming
SECTION 8:
Page 257 of 463