Table of Contents
Advertisement
5.14.3 LAN Interface
The LAN interface connector is installed on the rear panel. The MAC address of the unit can
be found near the LAN connector.
Do NOT connect the RJ45 LAN (Ethernet) connector of the power source to a PoE
(Power over Ethernet) port as the DC voltage will damage the LAN interface.
No special device drivers are required to use the LAN interface as it uses TCP/IP protocol but
the IP address needs to be configured to operate on the user's local area network or private
network.
5.14.4 Auxiliary I/O Connections
The AUX I/O connector contains synchronizing outputs (digital) and modulation inputs
(analog). These are extremely useful in certain test applications. The use of any of these
signals is optional and connection to these points is required only when these features are
used.
Note: When not in use however, make sure than any analog or digital programming inputs
are disabled on the controller or any noise picked up by these inputs may interfere
with programming from the front panel or digital interfaces.
The AUX I/O connector is located on the rear panel of the power source and is labeled as
such. This is a DB-25S Female connector. A DB-25P Male connector is required for
connection to AUX I/O connector.
All signals contained within the AUX I/O connector are low-level (less than ±12 VDC) and are
with respect to earth ground reference. Refer to the appropriate controller operation
manual for complete definition of the signals present on the AUX I/O connector.
For detailed information on AUX I/O signals and use, refer to Section 7 on page 177.
Entire Contents Copyright
2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
LMX Series Power Source Operation Manual
WARNING
LMX SERIES® OPERATION MANUAL
Unpacking and Installation
SECTION 5:
Page 85 of 463
Advertisement
Table of Contents
