Pacific Power Source LMX Series Operation Manual page 440

Error Source Code
Front panel 37
Front panel 42
Front panel 47
Front panel 48
Front panel 51
Front panel 53
Front panel 54
Front panel 56
Front panel 57
Front panel 58
Front panel 59
Front panel 60
Front panel 64
Front panel 65
Front panel 66
Front panel 67
Front panel 68
Front panel 69
Front panel 70
Front panel 72
Front panel 73

Entire Contents Copyright 2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
LMX Series Power Source Operation Manual
Category Error Message
Error Interface response packet
out of space.
Error Memory in use was
removed.
Error Front panel is shutting
down.
Error Fault state cannot be
automatically reset.
Error The command cannot be
executed in auxiliary unit.
Error Error during firmware
update.
Error Calibration coefficient
cannot be negative.
Error Waveform name is not
available.
Error Waveform file is not
available.
Error Waveforms lengths are
different between
controllers.
Error Unit does not exist.
Error Cannot read ambient
temperature
Error Unexpected reset.
Error Front panel is in passive
mode.
Error Invalid host name.
Error DC voltage set point
cannot change due to
waveform saturation.
Error AC voltage set point
cannot change due to
waveform saturation.
Error Maximum user limit is
lower than set point.
Error Minimum user limit is
higher than set point.
Error Minimum limit is higher
than maximum.
Error Maximum limit is lower
than minimum.
LMX SERIES™ OPERATION MANUAL
SECTION 12: Warnings & Error Messages
Possible Cause
Firmware Update Error.
Update may have failed
Negative Calibration
Coefficients are not
allowed
Waveform name
requested does not exist
Waveform register
selected is empty
Waveforms lengths are
not equal between three
phases
Unit selected cannot be
found
Inverter controllers were
reset
Passive Mode. Front
panel is most likely an
auxiliary unit
Host name requested is
invalid
Setting conflict.
Waveform data and DC
setting or in conflict
Setting conflict.
Waveform data and AC
setting or in conflict
Setting conflict. Set point
exceeds upper user limit
Setting conflict. Set point
is below lower user limit
Setting conflict. Max.
User Limit must be higher
than Min. User Limit
Setting conflict. Max.
User Limit must be higher
than Min. User Limit
Resolution
Check for correct
firmware image file and
version.
Make sure cal coefficients
are positive values
Use existing waveform
name from waveform
library
Download valid
waveform data to
selected register
Check waveform data for
correct length
Try recycling power. If
error persists, contact
customer service
Try recycling power. If
error persists, contact
customer service
Check parallel
configuration
Try recycling power. If
error persists, contact
customer service
Adjust DC setting or
waveform to resolve
conflict
Adjust AC setting or
waveform to resolve
conflict
Adjust setting or user
limit
Adjust setting or user
limit
Adjust User Limits
Adjust User Limits
Page 440 of 463