6.4.2
PROGRAM Output Parameters
The two data entry methods described apply to the parameters on the PROGRAM &
MEASUREMENTS screen. This includes those shown in the table below.
PARAMETER
Frequency
Voltage AC
Current limit
Power limit
kVA limit
Note 1: Range may differ for models with Transformer (T) Option.
Each screen has up to five soft keys on the right hand side of the display. These may change
as the selected parameter changes. To move between parameter fields in any screen, use
the shuttle knob. To change a parameter, press the shuttle knob and then adjust the value
by turning the shuttle. When done, press the shuttle to exit edit mode.
Entire Contents Copyright
2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
LMX Series Power Source Operation Manual
Figure 6-2: PROGRAM Screen
Range
15 - 5000
1
0 – 300
1
0 to Max
0 to Max
0 to Max
Table 6-2: Available Output Parameters on PROGRAM screen
LMX SERIES™ OPERATION MANUAL
SECTION 6:
Unit
Description
Hz
Output frequency
V rms
AC output
A rms
RMS Current Limit
W
True Power Limit
VA
Apparent Power Limit
Front Panel Operation
Page 94 of 463