Table of Contents
Advertisement
5.7.2
Output Neutral Grounding
The output neutral terminals of the power source are NOT connected to earth ground but
rather floating. This allows the output of the power source to float with respect to ground.
Some loads will have their neutral input grounded, which will result in the power source
neutral being grounded through the load. Alternatively, the user may ground the output
neutral terminals himself by running a suitable wire size from one of the output neutral
terminals to the ground stud on the rear panel of the power source.
Grounding the output neutral can help reduce common mode noise at the output of the
power source.
5.8 AC Input Circuit Breaker
This product is fitted with a mains input circuit breaker on the left hand side of the front
panel. The power off position of the circuit breaker handle is marked "O". The power on
position of the circuit breaker is marked "I".
5.9 Cleaning
BEFORE you clean the unit, switch the unit off at the front panel breaker AND remove all mains
power using the mains disconnect.
Please do NOT use any organic solvent capable of changing the nature of the plastic
•
such as benzene or acetone.
•
Please ensure that no liquid is allowed to penetrate this product.
AVANT de nettoyer l'appareil, mettez l'appareil hors tension au niveau du disjoncteur de face
avant ET retirez tout cable d´alimentation secteur.
Ne pas utiliser de solvant organique capable de changer la nature de la matière plastique
•
tel que le benzène ou l'acétone.
•
Veiller à ce qu'aucun liquide ne pénètre à l´intérieur de l´appareil
To clean this product, use a soft or slightly damp cloth.
Entire Contents Copyright
2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
LMX Series Power Source Operation Manual
CAUTION
ATTENTION
LMX SERIES® OPERATION MANUAL
Unpacking and Installation
SECTION 5:
Page 67 of 463
Advertisement
Table of Contents
