Pacific Power Source LMX Series Operation Manual page 442

Error Source Code
Front panel 101
Front panel 102
Front panel 103
Front panel 104
Front panel 105
Front panel 106
Front panel 109
Front panel 110
Front panel 111
Front panel 115
Front panel 116
Front panel 117
Front panel 118
Front panel 119
Front panel 120
Front panel 121

Entire Contents Copyright 2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
LMX Series Power Source Operation Manual
Category Error Message
Error AC voltage set point
cannot change due to
user limit.
Error DC voltage set point
cannot change due to low
range.
Error AC voltage set point
cannot change due to low
range.
Error Waveform change in
progress.
Error Error changing service
name
Error Error getting service
name
Error Transient step mode not
available on UPC
compatible mode.
Error System is about to
reboot.
Error Cannot reboot system.
Error Unable to renew the
DHCP lease. Changing to
Auto-IP mode.
Error Failed starting firmware
update.
Error Unable to execute this
action with output
enable.
Error Frequency set point
cannot change due to
waveform saturation.
Error Frequency set point
cannot change due to
user limit.
Error Frequency not allowed in
"DC mode".
Error Waveform set point
cannot change due to
waveform saturation.
LMX SERIES™ OPERATION MANUAL
SECTION 12: Warnings & Error Messages
Possible Cause
Setting conflict. Setting
outside of User Limits
Setting conflict. Setting
outside of User Limits
Setting conflict. Setting
outside of User Limits
Waveform change in
progress
Internal Service Error.
Could not change service
Internal Service Error.
Could not get service
name
Setting conflict. Step
mode only supported in
LMX mode.
Warning, Reboot
imminent
Soft reboot failed. Front
panel could not reboot
itself.
LAN Error. IP address
lease from DHCP expired
Firmware Update Error.
Unable to start firmware
update
Setting conflict.
Requested action not
possible with output ON
Setting conflict. In
extended voltage range,
frequency range is
restricted. Max peak
voltage is reduced
outside this range and if
there is a DC offset
programmed, the peak of
the voltage exceeds the
max. limit.
Setting conflict.
Frequency set point
outside User Limits
Setting conflict. No
frequency setting applies
in DC mode
Setting conflict. The crest
factor of the waveform
selected would result in a
peak voltage that exceeds
the max peak voltage
supported. Or combined
AC peak + DC
Resolution
Check setting
Check setting
Check setting
Wait
Try recycling power. If
error persists, contact
customer service
Try recycling power. If
error persists, contact
customer service
Switch to LMX mode or
use Segments
Wait
Try recycling power. If
error persists, contact
customer service
Renew IP lease of use
Auto IP mode
Check for correct
firmware image file and
version.
Turn output OFF
Reduce programmed
RMS and/or DC value.
Change User Limits or
frequency setting
Change to AC or AC+DC
mode
Reduce waveform crest
factor ratio or reduce
programmed RMS and/or
DC value.
Page 442 of 463