Table of Contents
Advertisement
6.6.3
LIST Transient Edit Mode
To create a new transient program, press the TRAN key to select the Transient screen. If no
transients have been entered or recalled, the initial screen will be blank.
The only available soft key is the "Create" key (SK1). Press the "Create" soft key to enter the
Transient Edit mode. This will display the TRANSIENT VIEW screen. Note that "Volt DC"
values are always fixed at 0.00 Vdc on LMX models.
In Edit mode, a number of soft keys are available to aid in editing new or existing transient
lists. They are defined in the following table.
SOFT KEY
Add at the end
(SK1)
Insert before (SK2) Insert a new table row before the current selected row. The
Delete (SK3)
Debug Mode (SK4) Displays the Debug Execution mode screen. See section 6.6.4
Entire Contents Copyright
2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
LMX Series Power Source Operation Manual
Figure 6-11: Blank TRANSIENT PROGRAM screen
Figure 6-12: TRANSIENT VIEW Edit Mode
Description
Adds a new row entry at the bottom of the transient list table. If
there are no table entries yet (new), pressing this key will add the
first line of a new transient table.
selected row and any rows below that are all pushed down one
position.
Deletes the current selected row. Any rows below the selected
row are pushed up one position.
Note: This action cannot be undone.
LMX SERIES™ OPERATION MANUAL
Front Panel Operation
SECTION 6:
Page 124 of 463
Advertisement
Table of Contents
