Pacific Power Source LMX Series Operation Manual page 241

Command Syntax
Description
Parameters
Parameter Format
Example
Query Format
Returned Data Format
Query Example
Command Syntax
Description
Parameters
Parameter Format
Example
Query Format
Returned Data Format
Query Example
Command Syntax
Description
Parameters
Parameter Format
Example
Query Format
Returned Data Format
Query Example
Command Syntax
Description
Parameters
Parameter Format
Example

Entire Contents Copyright 2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
LMX Series Power Source Operation Manual
PROGram:TRANsient:FROM
This command sets the first transient step number at which step
mode execution is to begin. The step specified must exist or an error
message will be generated.
STEP number from 1 ~ 99
<nr1>
PROG:TRAN:FROM 5
PROGram:TRANsient:FROM?
<nr1>
PROG:TRAN:FROM?
5
PROGram:TRANsient:TO
This command sets the transient step number at which step mode
execution is to end. The step specified must exist or an error message
will be generated.
STEP number from 1 ~ 99
<nr1>
PROG:TRAN:TO 25
PROGram:TRANsient:TO?
<nr1>
PROG:TRAN:TO?
25
PROGram:TRANsient:EVENts <nr1>
This command sets the number of repetitions for executing the
selected transient. A zero value is equivalent to infinite execution
until aborted by "PROG:TRAN STOP" command.
Repetition, range is 0 ~ 99999
<nr1>
PROG:TRAN:EVEN 5
PROGram:TRANsient:EVENts?
<nr1>
PROG:TRAN:EVEN?
5
PROGram:TRANsient:GOTO <nr1>
This command forces transient execution to move to the element
argument passed (STEP in STEP mode or SEGMENT in segment
mode).
ELEMENT
<nr1>
PROG:TRAN:GOTO 3
LMX SERIES™ OPERATION MANUAL
Remote Control Programming
SECTION 8:
Page 241 of 463