Table 6-21: Available Unit Configuration 2 Screen Soft Keys - Pacific Power Source LMX Series Operation Manual

Recall last settings at power-on When checked, this mode will cause the last settings that
Positive phase rotation
Invert polarity in split phase
Output disable zero program
Access to other utility screens is available from the UNIT CONFIGURATION screen through
the soft keys. The table below lists the available soft keys on the UNIT CONFIGURATION
screen.
SOFT KEY
Transient Settings (SK1)
Output Impedance (SK2)
User Presets (SK3)
Next Screen (SK5)

Entire Contents Copyright 2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
LMX Series Power Source Operation Manual
were in effect when the power source was last turned off to
be recalled at power on. This allows a user to resume
operation without having to set up again between power
on/off events.
When checked, the phase rotation in three phase mode will
be set to A -> C -> B corresponding to positive phase
rotation for three phase AC motors. To select negative
phase rotation, uncheck this option.
When checked, the AC waveform in split-phase mode of
operation is shifted 180° (inverted).
When checked, the programmed voltage is first set to zero
voltage when pressing the Output Enable button or
executing the OUTP OFF command. This allows any energy
stored in the EUT to dissipate into the low impedance
output of the power source before the relay disconnects the
load.
Description
Display Transient Configuration Settings
Program Output Impedance R and L values.
Access to user defined preset value settings for output
programming soft keys
Toggle to alternate UNIT CONFIGURATION screen

Table 6-21: Available UNIT CONFIGURATION 2 screen soft keys

LMX SERIES™ OPERATION MANUAL
Front Panel Operation
SECTION 6:
Page 140 of 463