Pacific Power Source LMX Series Operation Manual page 259

Command Syntax
Description
Parameters
Parameter Format
Example
Query Format
Returned Data Format
Query Example
Command Syntax
Description
Parameters
Parameter Format
Example
Query Format
Returned Data Format
Query Example
Command Syntax
Description
Parameters
Parameter Format
Example
Query Format
Returned Data Format
Query Example

Entire Contents Copyright 2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
LMX Series Power Source Operation Manual
[SOURce:]PHASe#:SLEW
This command sets slew rate for the phase angle for the selected
phase. A phase reference (#) must be specified.
Note that unless external sync mode is used, the A phase (# = 1) slew
rate cannot be programmed is fixed at 0 degrees.
0.01 – 359.91
<nr2>
PHAS3:SLEW 10.25
[SOURce:]PHASe#:SLEW?
<nr2>
PHAS3:SLEW?
10.2500
[SOURce:]PHASe:ROTation <b>
This command sets default phase rotation at power on. Available
settings are POSITIVE (1) or NEGATIVE (0). This setting effectively
swaps phases B and C and may be used to set the required phase
rotation for AC motors.
[ 0 | NEGative | 1 | POSitive]
0 = NEGATIVE
1 = POSITIVE
<b>
PHAS:ROT POS
[SOURce:]PHASe:ROTation?
<b>
PHAS:ROT?
1
[SOURce:]PHASe:SPLIT <b>
This command sets the split phase mirroring mode. This mode allows
non-symmetrical AC arbitrary waveforms to be used when in split
phase mode. Default state is on.
[ 0 | OFF| 1 | ON]
0 = OFF
1 = ON
<b>
PHAS:SPLIT ON
[SOURce:]PHASe:SPLIT?
<b>
PHAS:SPLIT?
1
LMX SERIES™ OPERATION MANUAL
Remote Control Programming
SECTION 8:
Page 259 of 463