Table of Contents
Advertisement
7.10 12 DC Power Supply
A pin in the DB25 port provides a current limited, regulated 12V supply. The maximum
current capability is 0.5Adc.
There are no menus or commands associated with this output, as it is always active.
7.11 RS232 Description
The Tx and Rx signal on the AUX I/O connector may be used to connect to a serial port. Only
Xon/Xoff handshake mode is supported on this RS232 port. For most situations, it is
recommended to use the USB Device port for remote serial control applications.
Entire Contents Copyright
2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
LMX Series Power Source Operation Manual
LMX SERIES™ OPERATION MANUAL
SECTION 7: Auxiliary I/OError! Reference source not found.
Page 194 of 463
Advertisement
Table of Contents
