User Limits & Presets - Pacific Power Source LMX Series Operation Manual

10.9.2 User Limits & Presets
User limits can be used to minimize operator error by setting upper and/or lower limits on
programmable parameter ranges.
Limits can be set for Voltage AC, Voltage DC and Frequency.
Note: When changing user limits, make sure programmed parameter settings in effect are not
outside the new upper and lower limits entered.
All user limits can be set from the CONFIGURATION -> USER LIMITS& PRESETS screen shown
below.
Extended range for voltage and frequency may be selected as needed. Some restrictions apply
when operating in extended range mode.
User programmable presets can be set to define the set values of the Soft keys in the program
screens. This allows commonly used setting values to be selected by an operator by just pressing
a single soft key. See image above for samples.

Entire Contents Copyright 2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
LMX Series Power Source Operation Manual
LMX SERIES™ OPERATION MANUAL
LAN Interface Configuration
SECTION 10:
Page 410 of 463