Harmonic Measurements Commands - Pacific Power Source LMX Series Operation Manual

8.4.9

Harmonic Measurements Commands

Harmonic Measurements commands may be used to retrieve harmonic analysis data for voltage and
current. These measurements are returned using the SPECTrum commands.
Query Format
Description
Returned Data Format
Query Example
Query Format
Description
Returned Data Format
Query Example
Query Format
Description
Returned Data Format
Query Example

Entire Contents Copyright 2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
LMX Series Power Source Operation Manual
MEASure:SPECTrum:VOLTage#[:MAGnitude]?
Returns harmonics spectrum for voltage on selected phase #. # = 1, 2
or 3. Returns a data set of 51, <nr2> type numbers, comma delimited.
The 1 st element is the magnitude of the fundamental, for reference.
The 2 nd element is the 2 nd
fundamental (relative).
Only a single spectrum may be queried in a command.
<nr2>, <nr2>, <nr2>,......, <nr2>
MEAS:SPECT:VOLT1?
100.000, 0.001, 0.3...., 0.000
MEASure:SPECTrum:VLL#[:MAGnitude]?
Returns harmonics spectrum for three phase Line to Line voltage on
selected phase #. # = 1, 2 or 3 (1 = Vab, 2 = Vbc, 3 = Vac). Returns a
VLL data set of 51, <nr2> type numbers, comma delimited. The 1
element is the magnitude of the fundamental, for reference. The 2
element is the 2 harmonic, etc. Values represent % of fundamental
nd
(relative).
Only a single spectrum may be queried in a command.
<nr2>, <nr2>, <nr2>,......, <nr2>
MEAS:SPECT:VLL1?
207.000, 0.001, 0.3...., 0.000
MEASure:SPECTrum:VLL#:ABSolute?
Returns absolute harmonics spectrum for three phase Line to Line
voltage on selected phase #. # = 1, 2 or 3 (1 = Vab, 2 = Vbc, 3 = Vac).
Returns a VLL data set of 51, <nr2> type numbers, comma delimited.
The 1 st element is the magnitude of the fundamental, for reference.
The 2 nd element is the 2 nd
fundamental (relative).
Only a single spectrum may be queried in a command.
<nr2>, <nr2>, <nr2>,......, <nr2>
MEAS:SPECT:VLL1:ABS?
207.000, 0.001, 0.3...., 0.000
LMX SERIES™ OPERATION MANUAL
Remote Control Programming
SECTION 8:
harmonic, etc. Values represent % of
harmonic, etc. Values represent % of
st
nd
Page 219 of 463