Table of Contents
Advertisement
6.6.5
LIST Transient Entry Modes
The LMX Series® supports two types of transient entry modes:
•
LIST STEP Mode
•
LIST SEGMENT Mode
Step mode is commonly used on AC and DC power sources that support the SCPI command
language as the SCPI standard defines a LIST, STEP and PULSE command syntax.
Segment mode is used on all Pacific Power sources with UPC controllers such as ASX and
AMX Series. Both modes support the same capabilities however.
Note that in STEP mode, two segment mode entries are combined so each STEP mode entry
requires two SEGMENT entries. The two transient examples below represent the same
transient display in either mode.
Entire Contents Copyright
2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
LMX Series Power Source Operation Manual
Figure 6-14: Transient shown in STEP Mode
Figure 6-15: Transient shown in SEGMENT Mode
LMX SERIES™ OPERATION MANUAL
Front Panel Operation
SECTION 6:
Page 127 of 463
Advertisement
Table of Contents
