Source:synchronize Commands - Pacific Power Source LMX Series Operation Manual

8.10.2 SOURce:SYNChronize Commands

SOURce:SYNChronize
[:INput][?]
SOURce:SYNChronize
:OUTPut[?]
8.10.2.1 SOURce:SYNChronize[:INput]
Command Syntax
Description
Parameters
Parameter Format
Example
Query Format
Returned Data Format
Query Example
Command Syntax
Description
Parameters
Parameter Format
Example
Query Format
Returned Data Format
Query Example

Entire Contents Copyright 2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
LMX Series Power Source Operation Manual
:PHASEshift[?}
:RANGE[?}
:SOURCE[?}
:SPeed[?}
:STATe?
SOURce:SYNChronize[:INput]
This command enables or disables the external sync input mode.
[ 0 | OFF | 1 | ON ]
<b>
SOUR:SYNC 1
SOURce:SYNChronize[:INput]?
<b>
SOUR:SYNC?
1
SOURce:SYNChronize[:Input]:PHASEshift <nr2>
Defines a fixed phase shift between phase A waveform generation
and the external sync source. Used to calibrate any phase difference
between the sync signal and the power source output on phase A.
Phase shift
<nr>
SOUR:SYNC:PHASE 2.8
SOURce:SYNChronize[:Input]:PHASEshift?
<nr2>
SOUR:SYNC:PHASE?
0.5
LMX SERIES™ OPERATION MANUAL
Remote Control Programming
SECTION 8:
Page 350 of 463