Pacific Power Source LMX Series Operation Manual page 452

Error Source Code
Controller 484
Controller 486
Controller 487
Controller
488
Controller 489
Controller 492
Controller 493
Controller 494
Controller 497
Controller 498
Controller 499
Controller 500
Controller 501
Controller 502
Controller 503
Controller 504
Controller 505
Controller 506
Controller 507
Controller 508
Controller 509
Controller 510
Controller 519
Controller 520
Controller 520
Controller 521
Controller 521
Front panel 600

Entire Contents Copyright 2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
LMX Series Power Source Operation Manual
Category Error Message
Internal Incorrect DSP type
Error detected. Cycle-power to
re-try.
Error Controller missed
heartbeats from master
front panel.
Error Output over-voltage
protection.
Internal Invalid constants loaded
Error from EEPROM.
Fault Output current peak
protection.
Internal CLA task timeout.
Error
Error CSC loop has saturated.
Error Output current overload.
RMS current exceeded
limit.
Error Emergency shutdown.
Error Exceeded under RMS
voltage limit.
Error Exceeded over RMS
voltage limit.
Internal CPU1 invalid fault.
Error
Internal CPU2 invalid fault.
Error
Internal Firmware mismatch
Error between CPUs.
Internal Bootloader firmware
Error mismatch between CPUs.
Error Power module not
connected.
Error Master disabled.
Error Two masters detected.
Error Power module shutdown.
Error Power module coupling
mismatch.
Error Power module form
mismatch.
Error Power module not
detected.
Internal Controller is not in
Error operational node.
Error Forced fault.
Internal Missing controller node.
Error
Error Output current RMS
exceeded limit.
Internal Cannot read fault
Error information.
Warning AC voltage set point was
automatically reduced to
0 Vrms.
LMX SERIES™ OPERATION MANUAL
SECTION 12: Warnings & Error Messages
Possible Cause Resolution
Page 452 of 463