Pacific Power Source LMX Series Operation Manual page 64

Models 105LMX, 108LMX, 112LMX, 305LMX, 308LMX, 312LMX and 320LMX are supplied
with an AC input power cord. Install an appropriate plug onto the end of the power cord
and connect to the proper outlet. Refer to Section 4.8 for recommended input service of
the configured input voltage form.
SINGLE PHASE
THREE PHASE
The input power of Models 140LMX, 160LMX, 345LMX and 360LMX is connected to the
Input Power Terminal Block located on the rear panel of the power source. In this case, the
input wiring is brought to this terminal block from the distribution panel. The connection
points are labeled "A," "B," "C," "N," and "CHS."
The input wiring is connected to these points in the appropriate order with CHS being the
safety ground or earth potential. The LMX-Series Power Sources are not sensitive to phase
rotation of the input voltage. For all standard DELTA input voltage forms (208, 220, and
240VAC) and WYE input voltage forms (220/380VAC, 230/400VAC 240/416VAC, and
277/480VAC), the "N" (Neutral) terminal is not used. Refer to Figure 5-6 for the proper wire
size to be used with the configured input power form.
Note: It is the user's responsibility to meet all local and national electrical codes when
installing this equipment.

Entire Contents Copyright 2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
LMX Series Power Source Operation Manual
LINE ( HI )
NEUTRAL ( LO )
GROUND ( CHS )
LINE 1 ( L1 or A )
LINE 2 ( L2 or B )
LINE 3 ( L3 or C )
GROUND ( CHS )
LMX SERIES® OPERATION MANUAL
Unpacking and Installation
SECTION 5:
Wire Color Wire Color
( US Models ) ( CE Models )
Black
White
Green Green/Yellow
Black
White
Red
Green Green/Yellow
Brown
Blue
Brown
Black
Grey
Page 64 of 463