Table of Contents
Advertisement
Under development
This document is under development and its contents are subject to change.
M16C/6N5 Group
Acceptance Filtering Function and Masking Function
These functions serve the users to select and receive a facultative message. The C0GMR register, the
C0LMAR register, and the C0LMBR register can perform masking to the standard ID and the extended ID
of 29 bits. The C0GMR register corresponds to slots 0 to 13, the C0LMAR register corresponds to slot 14,
and the C0LMBR register corresponds to slot 15. The masking function becomes valid to 11 bits or 29 bits
of a received ID according to the value in the corresponding slot of the C0IDR register upon acceptance
filtering operation. When the masking function is employed, it is possible to receive a certain range of IDs.
Figure 1.19.22 shows correspondence of the mask registers and slots, Figure 1.19.23 shows the acceptance
function.
Figure 1.19.22 Correspondence of Mask Registers to Slots
ID of the
received message
Figure 1.19.23 Acceptance Function
When using the acceptance function, note the following points.
(1) When one ID is defined in two slots, the one with a smaller number alone is valid.
(2) When it is configured that slots 14 and 15 receive all IDs with Basic CAN mode, slots 14 and 15
receive all IDs which are not stored into slots 0 to 13.
Rev.1.00
2003.05.30
page 220
C0GMR register
C0LMAR register
C0LMBR register
ID stored in
The value of the
the slot
mask register
Slot #0
Slot #1
Slot #2
Slot #3
Slot #4
Slot #5
Slot #6
Slot #7
Slot #8
Slot #9
Slot #10
Slot #11
Slot #12
Slot #13
Slot #14
Slot #15
Mask Bit Values
0: ID (to which the received message
corresponds) match is handled as
"Don't care".
1: ID (to which the received message
corresponds) match is checked.
Acceptance Signal
Acceptance judge signal
0: The CAN module ignores the
current incoming message.
(Not stored in any slot)
1: The CAN module stores the
current incoming message in
a slot of which ID matches.
CAN Module
Advertisement
Chapters
Table of Contents
