ABB DressPack IRB 6640 Product Manual page 311

2
3
4
5
6
Product manual - DressPack/SpotPack IRB 6640
3HAC028638-001 Revision: K
Action
The figure to the right, shows the fitting po-
sitions of the slide sleeves on the
cable/hose retainer.
Secure the slide sleeves with hose clamps.
In applications where a large number of
cables/hoses are used, aluminum cable
clamps may be used, to compress the entire
package.
The slide sleeves are correctly tightened
when a fully tightened aluminum cable
clamp (for example on the tension arm unit)
and the process cable support axis 6 allows
some swivelling.
Check that the cables and hoses are in the
right position.
Refit the cable package in the ball joint
housing.
Reconnect cable and hose connectors.
© Copyright 2007-2018 ABB. All rights reserved.
4.3.2 Replacement of slide sleeves
Note
The figure shows a cross section of the
slide sleeves:
xx0400001007
Parts:
• A: Protective hose
• B: Hose reinforcement
• C: Slide sleeves
• D: Hose clamp
• E: Cable/Hose retainer
Make sure both clamps face the same
way!
Make sure the gaps between the slide
sleeve halves are close to identical and
do not coincide with the vertical cuts in
the hose and cable retainer!
xx0300000250
• Hose clamp
Use the makings of the reinforced tape
done earlier.
4 Repair
Continued
311