ABB DressPack IRB 6640 Product Manual page 184

2 Installation
2.6.1 Installation of Water and air unit
Continued
Shop compressed air supply
Use this procedure to connect the Water and Air unit to the shop compressed air
supply.
1
2
Water drain connection, One water return
Use this procedure to connect the water drain connection with one water return,
to the Water and Air unit.
1
2
Continues on next page
184
Action
Type S:
Connect the air hose to the fitting with a
G½" thread on the air shut off valve (C).
CAUTION
Do not tighten the brass couplings for water
and air with excessive force.
Type Sb:
Connect the air hose to the fitting with a
G½" thread on the air shut off valve (A).
CAUTION
Do not tighten the brass couplings for water
and air with excessive force.
Action
Route the water drain hose through the
lower hole in the mounting plate.
Connect the hose to the fitting with a G½"
thread on the check-valve.
CAUTION
Do not tighten the brass couplings for water
and air with excessive force.
© Copyright 2007-2018 ABB. All rights reserved.
Note
Shown in the figure in section
tions to Water and Air unit, type S on
page 181.
Tightening torque, brass couplings 1/2":
31 Nm
Tightening torque, brass couplings 3/8":
17 Nm
Shown in the figure in section
tions to Water and Air unit, type Sb on
page 182.
Tightening torque, brass couplings 1/2":
31 Nm
Tightening torque, brass couplings 3/8":
17 Nm
Note
xx0600003348
• B: Water drain connection, one
water return
Product manual - DressPack/SpotPack IRB 6640
3HAC028638-001 Revision: K
Connec-
Connec-