ABB DressPack IRB 6640 Product Manual page 177

Parameter
Air quality
Required equipment
Equipment, etc
Water and Air unit,
type S
Water and air unit,
type Sb
Standard toolkit,
DressPack/SpotPack
Reference documents
Document
Circuit diagram - SpotPack
SWC IRC5 M2004
Circuit diagram - SpotPack
SWC IRC5 Design 2014
PROFINET
Installation of Water and air unit, type S
The procedure below details how to install the Water and Air unit, type S on the
robot base.
1
Product manual - DressPack/SpotPack IRB 6640
3HAC028638-001 Revision: K
Art. no.
For spare part number
see chapter:
• Spare parts on
page
For spare part number
see chapter:
• Spare parts on
page
3HAC17290-7
Document number
3HAC026208-001
3HAC044736-001
Action
DANGER
Turn off all:
• electric power supply
• hydraulic pressure supply
• air pressure supply
to the robot, before entering the robot working
area.
© Copyright 2007-2018 ABB. All rights reserved.
2.6.1 Installation of Water and air unit
Value
Use clean air.
When there is excessive condensate, install
a device that will eliminate water, such as a
dryer or water separator (Drain Catch) on the
inlet side of the air filter.
Note
A number of versions are available.
339.
A number of versions are available.
339.
The contents are defined in section
Toolkits, DressPack/SpotPack on page
Note
Valid for all robots without
PROFINET.
Valid for all robots with option 782-
13 Bosch MFDC PROFINET.
Note
2 Installation
Continued
335.
Continues on next page
177