ABB DressPack IRB 6640 Product Manual page 251

8
9
Product manual - DressPack/SpotPack IRB 6640
3HAC028638-001 Revision: K
4.2.8 Replacement process cable package IRBDP SW4 UI (IRB66X0ID)
Action
Front:
Loosen the screws, M6x60 (4 pcs) that
are locking the process cable package
in position at the holder front.
This is done in order to release the
tension in the process cable package.
Note
Do not remove the screws completely
at this point!
Back and front together:
Front:
Pull out the cables and hoses a little
from their holes, one by one.
Back:
Push the cables and hoses forward,
one by one.
© Copyright 2007-2018 ABB. All rights reserved.
Note
xx0500001944
Parts:
• A: Holder front
• B: Hex socket head cap screw M6x60
xx0500002502
This procedure is done in order to make it
possible to remove the covers from the hoses
and cables in the turning disk unit.
Due to long operation the cable package may
be jammed.
Depending on the cable package shall be re-
used or not, follow the appropriate advice
below:
• If the cable package shall be reused
do not be afraid to pull harder to get
the cables out. Still be careful not to
damage it!
• If the cable package is scrap pull the
cable package out far enough to make
it possible to cut off cables and hoses.
Continues on next page
4 Repair
Continued
251