ABB DressPack IRB 6640 Product Manual page 288

4 Repair
4.2.12 Replacing the protection hose - IRBDP SW6 UI and MH6 UI - Upper arm
Continued
6
Refitting step 3 - Cable and hose retainer (wrist)
Use this procedure to fit the clamp jaw (wrist).
1
Continues on next page
288
Action
Check that the screws on the hose clamps
are fitted in the correct position.
Note
Do not place the screws on the outside of
the hose reinforcement funnel!
On top, below or (as shown in the figure)
on the inside are all correct placement of
the screws.
Action
Arrange cable and hoses according to their
position in the cable and hose retainer.
© Copyright 2007-2018 ABB. All rights reserved.
Note
xx1200000112
Note
PROC 4
SP
CPS
WELD EARTH
WELD V
xx1200000106
Note
This is an example showing the Paracom
cable harness. If in doubt check the posi-
tions on a cable and hose retainer that still
is fitted.
Product manual - DressPack/SpotPack IRB 6640
3HAC028638-001 Revision: K
PROC 3
PROC 2
FB7
PROC 1
WELD U