ABB DressPack IRB 6640 Product Manual page 183

xx0800000122
Item in figure
A
B
C
D
E
F
G
Shop water supply
Use this procedure to connect the Water and Air unit to the shop water supply.
1
2
3
Product manual - DressPack/SpotPack IRB 6640
3HAC028638-001 Revision: K
Connect to:
Shop compressed air supply
PROC 1 on robot base
PROC 2 on robot base
PROC 3 on robot base
Shop water supply
Shop water drain
PROC4 on robot base (option)
Action
Route the water supply hose through the
upper hole in the mounting plate.
Type S:
Connect the hose to the fitting with a G½"
thread on the solenoid valve (A).
CAUTION
Do not tighten the brass couplings for water
and air with excessive force.
Type Sb:
Connect the hose to the fitting with a G½"
thread on the solenoid valve (C).
CAUTION
Do not tighten the brass couplings for water
and air with excessive force.
© Copyright 2007-2018 ABB. All rights reserved.
2 Installation
2.6.1 Installation of Water and air unit
Function:
Compressed air supply to robot
Water in circuit
Water return circuit
Depending on option selected:
• Regulated air
Note
Shown in the figure in section
tions to Water and Air unit, type S on
page 181.
Tightening torque, brass couplings 1/2":
31 Nm
Tightening torque, brass couplings 3/8":
17 Nm
Shown in the figure in section
tions to Water and Air unit, type Sb on
page 182.
Tightening torque, brass couplings 1/2":
31 Nm
Tightening torque, brass couplings 3/8":
17 Nm
Continues on next page
Continued
Connec-
Connec-
183