12-914 Stacker Tray Staple Set
The Staple Set count of the Stacker Tray exceeded 50 sets at the Staple Set Eject operation.
Initial Actions
Check the actuator of the Stacker Paper Sensor for smooth operation
Procedure
Remove the Stapled Sets. The problem continues.
Y
N
Return to Service Call Procedures.
Enter
dC330
[012-200] and press Start. Actuate the Stacker Paper Sensor
display changes.
Y
N
Press Stop. Check the circuit of the Stacker Paper Sensor
2
RAP for troubleshooting procedure.
Press Stop.
•
Ensure that the connectors shown in the circuit diagram
nected and that the wires are not damaged.
•
Replace the Stacker Paper Sensor
•
If the problem persists, replace the Finisher PWB
Stack
Height
Sensor
Figure 1 Component Location
Initial issue
DC 3535/2240/1632, WC M24
(Figure
1).
(Figure
(Figure
2). Refer to the
(Figure
2) are securely con-
(PL
17.11).
(PL
17.13)
(Figure
3).
Stacker
Paper
Sensor
Stacker
Motor
2). The
OF 99-
Figure 2 12-914 RAP Circuit Diagram - Stacker Paper Sensor
09/03
2-291
Figure 3 Finisher PWB
Status Indicator RAPs
12-914