Stp Port Priority; Stp Priority - Huawei Quidway S2000 Series Command Manual

Command Manual - STP
Quidway S2000 Series Ethernet Switches
By default, the value is auto.
The requirements of current port connects to point-to-point link are current port is the
master of an aggregated port or it works in full-duplex mode. The default setting, that
is, checking by RSTP automatically is recommended.
Example
# Indicate that the link to Ethernet 0/1 is point-to-point link.
[Quidway-Ethernet0/1] stp point-to-point force-true

1.1.11 stp port priority

Syntax
stp port priority port-priority
undo stp port priority
View
Ethernet port view
Parameter
port-priority: Specifies the priority of the port, ranging from 0 to 240. The values are not
consecutive integers. Step length is 16. By default, the value is 128.
Description
Using stp port priority command, you can configure the priority of the current
Ethernet port. Using undo stp port priority command, you can restore the default
priority.
The priority value shall be a multiple of 16, such as 0, 16, 32, 48 etc. The smaller value
represents the higher priority. A port with higher priority is more likely to be a root port.
Example
# Set the priority of Ethernet 0/1 to 64.
[Quidway-Ethernet0/1] stp port priority 64

1.1.12 stp priority

Syntax
stp priority bridge-priority
undo stp priority
View
System view
Chapter 1 RSTP Configuration Commands
1-9