Adjusting Toe Setting At Rear Wheels - Seat Leon 2013 Workshop Manual

– To do so, use insert tool - T10179- .
On use of insert tool - T10179- , tighten nuts to 80 Nm.
– Check camber value again after nut -A- has been tightened.
– Check camber value again after tightening nut -A-
⇒ "1.4 Specified values for wheel alignment", page 294
Specified torques
♦ ⇒ "5.1 Assembly overview - transverse links", page 195
1.10

Adjusting toe setting at rear wheels

⇒ "1.10.1 Adjusting toe setting at the rear wheels - vehicle with
torsion beam axle", page 307
⇒ "1.10.2 Adjusting toe on rear axle, multi-link suspension", page
307
1.10.1 Adjusting toe setting at the rear wheels
- vehicle with torsion beam axle
The convergence of the rear axle cannot be adjusted.
If the measurements are outside the permitted tolerances, check
the axle beam for damage and renew if necessary.
1.10.2 Adjusting toe on rear axle, multi-link sus‐
pension
Special tools and workshop equipment required
♦ Torque wrench - V.A.G 1332-
León 2013 ➤ , León ST 2013 ➤
Running gear, axles, steering - Edition 06.2018
.
.
307
1. Wheel alignment